Saturday, October 11, 2008

Cubic Zirconia Prong Ring

Latest prong ring with cubic zirconia. This is an experimental piece with gold filled wire. Since I only have a size 24ga wire, it is a bit too thin for the prong. A thicker wire would hold the stone tighter. 
Wire wrapped prong ring with cubic zirconia - This is an experimental piece with gold filled wireWire wrapped prong ring with cubic zirconia - This is an experimental piece with gold filled wireSide view of the wire wrapped prong ring with cubic zirconia - This is an experimental piece with gold filled wire Wire wrapped prong ring with cubic zirconia - This is an experimental piece with gold filled wire

7 comments:

  1. AnonymousSunday, October 12, 2008 at 1:10:00 PM GMT+8

    this is good..another creation that can use limited size of gold wire..thank mei for your inspiration..

    ReplyDelete
  2. Mei TanSunday, October 12, 2008 at 10:29:00 PM GMT+8

    Your are welcome Yati.

    ReplyDelete
  3. AnonymousWednesday, October 15, 2008 at 3:38:00 AM GMT+8

    Nice. Could the ss, brass, or copper wire purchased in craft stores be used for the same???

    ReplyDelete
  4. Mei TanWednesday, October 15, 2008 at 8:27:00 AM GMT+8

    thank you. Yes, you can use ss, brass or copper wire for this ring.

    ReplyDelete
  5. AnonymousMonday, October 20, 2008 at 2:49:00 AM GMT+8

    Cool........is there a certain guage on the ss, brass or copper wire bought in craft stores that you would recommend?

    ReplyDelete
  6. Mei TanMonday, October 20, 2008 at 8:20:00 AM GMT+8

    I guess personal preference also decide which gauge to use but not finer than 24ga though. Personally I would recommend 22ga.

    ReplyDelete
  7. AnonymousMonday, October 20, 2008 at 10:42:00 PM GMT+8

    Okay, I will check to see if I have already purchased any of the 24ga and the 22 ga. Thanks Mei.
    Love your site.

    ReplyDelete

I like to hear what you have in mind. Thank you for your time.