Saturday, October 11, 2008

Cubic Zirconia Prong Ring

Latest prong ring with cubic zirconia. This is an experimental piece with gold filled wire. Since I only have a size 24ga wire, it is a bit too thin for the prong. A thicker wire would hold the stone tighter. 
Wire wrapped prong ring with cubic zirconia - This is an experimental piece with gold filled wireWire wrapped prong ring with cubic zirconia - This is an experimental piece with gold filled wireSide view of the wire wrapped prong ring with cubic zirconia - This is an experimental piece with gold filled wire Wire wrapped prong ring with cubic zirconia - This is an experimental piece with gold filled wire

7 comments:

  1. this is good..another creation that can use limited size of gold wire..thank mei for your inspiration..

    ReplyDelete
  2. Nice. Could the ss, brass, or copper wire purchased in craft stores be used for the same???

    ReplyDelete
  3. thank you. Yes, you can use ss, brass or copper wire for this ring.

    ReplyDelete
  4. Cool........is there a certain guage on the ss, brass or copper wire bought in craft stores that you would recommend?

    ReplyDelete
  5. I guess personal preference also decide which gauge to use but not finer than 24ga though. Personally I would recommend 22ga.

    ReplyDelete
  6. Okay, I will check to see if I have already purchased any of the 24ga and the 22 ga. Thanks Mei.
    Love your site.

    ReplyDelete

I like to hear what you have in mind. Thank you for your time.